SUPER PULSAR 100
Kit Content
| Pre Molded Composites Parts | Ribs - Horizontal Stabilizer | Poly-flow tubing |
| Fuselage & Vertical Stabilizer - Left | Ribs - Ailerons | Air vents Frame |
| Fuselage & Vertical Stabilizer - Right | Ribs - Flaps | Aileron Mass Balance Weight |
| Main Wing Spar - Left | Vertical Stabilizer Forward Spar | Aluminum Flat Stock |
| Main Wing Spar - Right | Rudder Pivot Plate | Aluminum Angle Bar |
| Aft Wing Spar - Left | Rudder Bell crank | Aluminum Rectangular Channel |
| Aft Wing Spar - Right | Brackets | Clevis Fork |
| Wing Skin - Top Left | Actuator Arm - Elevator | Aluminum Tubing |
| Wing Skin - Top Right | Foam | Fuel Line |
| Wing Skin - Bottom Left | Fuel Drain Mount | Rudder Cable |
| Wing Skin - Bottom Right | Main Landing Gear | Standard Fasteners and Components |
| Wing D-Section - Left Inboard | Nose Gear Assy | Bolts, Screws, Washers, Nuts, Spacer, Bearings |
| Wing D-Section - Right Inboard | Wheels, Tires & Brake (Hyd.) Kit | Rivets, Cotter Pins |
| Wing D-Section - Left Outboard | Push Rod Guide Plate | Rod Ends, Bushings, Sleeves, Coil Spring |
| Wing D-Section - Right Outboard | Bell cranks | Roll Pin, Fittings |
| Wing Tip - Left | Push Rod | Hinges |
| Wing Tip - Right | Brake Pedals | Static Port, Lines & Fittings |
| Canopy Frame | Gas Spring Strut | Airspeed Tubing |
| Landing Gear Channel Box | Rudder Pedal Assy, Left | Quick Drain |
| Vertical Stabilizer Spar | Rudder Pedal Assy, Right | Fuel Selector Valve |
| Rudder - Left | Control Stick | Fuel Cap Assy |
| Rudder - Right | Elevator Push Pull Tube | Grip, Control Stick |
| Horizontal Stabilizer & Elevators - Top | Composite Materials & Supplies | Canopy Latch |
| Horizontal Stabilizer & Elevators - Bottom | Structural Adhesive | Instructions and Templates |
| Composite Flat Panels | Epoxy Resins | Builders Manual |
| Tail Cone | 5 min Epoxy Adhesive | Template Sheets |
| Wheel Pants | Fuel Tank Sealant | Template, Wing Jig |
| Instrument Panel | Fiberglass Cloth | |
| Pre Fabricated Special Components | Fiberglass Tapes | |
| Aileron - Left | Peel Ply | |
| Aileron - Right | Cab-o-Sil | |
| Flaps - Left | Flox | |
| Flaps - Right | Micro Balloons | |
| Canopy | Mixing Sticks | |
| Wing Ribs - Left | Mixing Cups | |
| Wing Ribs - Right | Miscellaneous Materials | |
| Ribs- Elevator | Lead Shots |
The Kit contains all composite parts and hardware to complete the airplane.
In addition to the above, you should budget for engine, firewall forward, avionics, instruments, electrical, paint and upholstery.